Took another good look at the mounts I had made for my headset connections and realized that they weren't going to work with the baggage bag and they were about a half inch away from the flaperon control rod that runs through that section. So I came up with a different bracket. This bracket fits much lower in the same area by the rear windows but is cut to allow the baggage bag attachment and clear the connectors. So the bag will fit over the plate that gets Hysol'd on to the frame and I'll just cut the holes in the bag for the connectors. On top of the bag after it's installed, I have a second plate that is drilled to mount the connectors themselves; normal headset and mic jacks, a LEMO connector and a 3.5mm jack that I can connect GoPros to and record the intercom and radio. This plate will also hold the bag in place and keep it from fraying. I also managed to get the roll servo wired up as well. Tomorrow it will probably be the GPS 20 that gets some wiring done to it.